Soldering the Flight Controller - Drone Building 101 - Hak5 2003

Hak5

Soldering the Flight Controller - Drone Building 101 - Hak5 2003

We continue our drone build by soldering the flight controller and finalizing the motor wiring!

-------------------------------
Shop: hakshop.com
Support: patreon.com/threatwire
Subscribe: youtube.com/hak5
Our Site: hak5.org
Contact Us: twitter.com/hak5
------------------------------
Check out Episode 20x01 and 20x02 for the first two parts of this series.

Carbon Fiber 210 mm H frame (QAV210 or similar)
amzn.to/21hoCB8
amzn.to/1X7m5Zg

Power Distribution Board with 5 Volt and 12 Volt regulators
amzn.to/1X7m7QJ

M2 Nylon Standoffs and Screws
amzn.to/1QC96hM

NAZE32 Flight Controller
amzn.to/1X7meMi

4x 20 Amp Electronic Speed Controllers with BLHeli firmware
amzn.to/1TEXOMm

4x Brushless Motors, either 1804 2300-2400KV or 1306 3100KV
amzn.to/1QC9bC4
amzn.to/1TEXUDy

4x Carbon Fiber 5030 Propeller either 3-hole or 1-hole depending on motor mount (2 clockwise, 2 counter-clockwise)
amzn.to/1QC9eOh
amzn.to/1QC9hcM

1x Spektrum compatible DSM2 or DSMX Satellite Receiver
amzn.to/1QC9iNR
amzn.to/1TEY1PJ